Filter
Top Products
-2-
1. Reorient or relocate the receiving antenna
2. Increase the separation between the equipment and receiver
3. Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected
4. Consult the dealer or an experienced radio/TV technician for help
Use of shielded cable is required to comply with Class B limits in Subpart B of Part 15 of the FCC
rules. Do not make any changes or modifications to the equipment unless otherwise specified in
the manual. If such changes or modifications should be made, you could be required to stop
operation of the equipment.
1.2.2 GENERAL WARNINGS
Do not use batteries other than those specified for use with the camera. The use of unsuitable
batteries may result in the batteries splitting or leaking and causing a fire, injury, or soiling of the
battery compartment.
When placing batteries in the camera, check the polarity of the batteries (- and +) to ensure proper
orientation. Incorrect polarity may result in the batteries splitting or leaking and causing a fire, injury,
or soiling of the battery compartment.
Remove the batteries if the camera will not be used for an extended period of time. The batteries
may leak and cause a fire, injury or soiling of the battery compartment. If the batteries leak clean
and wipe the battery compartment carefully and install new batteries. Wash your hands carefully if
you touch the battery fluid. Please note that when you remove the batteries your images will be lost
from the camera memory.
WARNING: Handling the USB cable on this product may expose you to lead, a chemical known to
the State of California to cause birth defects or other reproductive harm. Wash your hands after
handling.