Filter
Top Products
55
Reference
- Install the USB driver before
you connect the camera to a
connecting to a computer with
Cannot transfer images after
USB cable.
PC.
- Turn on the camera.
- USB driver is not installed.
- Camera is turned off.
If the low-battery indicator
appears on the camera LCD
screen, replace batteries with a
subjects, use the camera to
Normal/Infinity focus mode.
- Hold the camera steady when
- Be sure that there is at least
80cm between the camera
- Use the macro mode to shoot
close-ups images at a
- When shooting distance
- Turn your mode dial to Auto
mode or Manual mode.
- Wait until the flash charging
- Delete images you no longer
This camera can not display
Set the flash to any other mode
appropriatedsetting, NTSC or
- Please use the attached video
cable to connect the camera
- Set the video system to the
Recorded images are not
Images are nor displayed.
The flash doesn't fire.
Image not showing on TV.
saved in memory
full set of new ones.
non-DCF images.
except Off.
to the TV correctly.
PAL for your TV
complete.
the save operation is
Camera power down before
A memory card with non-DCF
images recorded with another
camera is loaded in the
camera.
The flash mode is set to Off.
- There is a problem with the
camera-TV connection.
- Incorrect video system
setting.
Images are blurry or unfocused.
Image is not recorded when
the shutter release button is
pressed.
shooting.
lens and the subject.
distance of 20cm.
- The camera was moving
can focus.
range over which the camera
- The subject was out of the
when you took images.
finishes
need.
- Memory is full.
- Flash is in charge.
Playback mode.
- The mode dial is set to
Problem Cause Action