Filter
Top Products
Getting Started
2
General Precautions
n Do not try to open the case of the camera or attempt to modify this camera in any way.
High-voltage internal components create the risk of electric shock when exposed. The
maintenance and repairs should be carried out by authorized service providers.
n Do not fire the flash when it is too close to people or animal’s eyes. It may cause eye
damage especially for children.
n Do not use this camera with wet hand. Keep the camera away from water and other
liquids. Moisture creates the danger of fire and electric shock. Never use this camera
in the rain or snow.
n For safety reasons, please keep this camera and accessories out of reach of children
or animals to prevent accidents.
n If you notice smoke or a strange odor coming out of the camera, immediately turn
power off and unplug the AC adaptor from the power outlet. Take it to your nearest
service center for repair. Never attempt your own maintenance.
FCC Compliance and Advisory
This device complies with Part 15 of the FF Rules. Operation is subject to the following
two conditions: 1.) this device may not cause harmful interference, and 2.) this device
must accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits for a Class B peripheral,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communication.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause a harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures.
n Reorient or relocate the receiving antenna.
n Increase the separation between the equipment and receiver.
n Connect the equipment into an outlet ton a circuit different from that to which the
receiver is connected.
n Consult the dealer or an experienced radio/TV technician for help.
Any changes or modifications not expressly approved by the party responsible for