Filter
Top Products
VIVOTEK - A Leading Provider of Multimedia Communication Solutions
42 - User's Manual
Exposure level:
You can manually set up the Exposure level, which ranges from 1 to 8. The default value is 4.
AGC (Auto Gain Control):
You can manually set up the AGC level (2X, 4X, or 8X). The default value is 4X.
Enable auto iris:
Select it to enable the auto iris function.
Enable WDR (Wide Dynamic Range):
Select it to enable the WDR function. This
Network Camera with WDR feature can cope with very
challenging lighting conditions. It is capable of capturing both of the dark part and bright part of a target and
combining the differences into a scene to generate a highly realistic image as the human eyes can see.
Note that if you select this function, Exposure level and AGC function will be disabled.
Switch to B/W in night mode:
Select it to enable the Network Camera to automatically switch to B/W in night mode.
IR cut filter:
With a removable IR-cut filter and built-in IR illuminators, up to 15m, this Network Camera can automatically
remove the filter and turn on the IR illuminators during the nighttime to accept IR illumination for low light
sensitivity.
■ Auto
The Network Camera automatically
removes the filter
by judging the level of ambient light.
■ Schedule mode
The Network Camera switches between day mode and night mode based on specified schedule.
Enter the starting time and ending time for the day mode. Note that the time format is [hh:mm] and is
expressed in 24-hour clock time. By default, the starting time and ending time of day mode are set to
07:00 and 18:00.
■ Day mode
In day mode, the Network Camera switches on the IR cut filter at all times to block the infrared light
from reaching the sensor so that the colors will not be distorted.
■ Night mode
In night mode, the Network Camera switches off (remove) the IR cut filter to allow the infrared light to
pass through. This improves the sensitivity of the Network Camera in low-light conditions.
You can click Preview to fine-tune the image, or click Restore to recall the original settings without
incorporating the changes. When completed with the settings on this page, click Save to take effect and
click Close to quit the page.
Video quality settings for stream 1 / stream 2: You can set up two seperate streams for the Network
Camera for different viewing devices. For example, set the Network Camera to a smaller frame size and
a lower bit rate for remote viewing on mobile phones. Or, set the Network Camera to a larger video size
and a higher bit rate for live viewing on web browsers.
■ Mode
The Network Camera offers two choices of video compression standards for real-time viewing: MPEG-4
and MJPEG.