Filter
Top Products
VIVOTEK
User's Manual - 97
NOTE
►
The Preset Positions will also be displayed on the home page. Select one from the Go to drop-down
list, and the Network Camera will move to the selected preset position.
►
Click Patrol: The Network Camera will patrol along the selected positions repeatedly.
NOTE:
PTZ
Mechanical PTZ Operation
If you select “Mechanical“, the RS485 Settings section will be displayed as shown below:
RS485 Settings
Disable: Select this option to disable this function.
PTZ camera: Select this option to enable PTZ operation.
To utilize this feature, please connect the Network Camera to a PTZ driver or scanner via RS485 serial
interface rst. Then you can congure the PTZ driver and RS485 port with the following settings.
VIVOTEK provides five PTZ drivers: DynaDome/SmartDOME, Lilin PIH-7x00, Pelco D, Pelco P, and
Samsung Scc643 protocol� If none of the above PTZ drivers is supported by your PTZ scanner, please
select Custom camera (scanner)� Please refer to the documentation of your PTZ scanner to determine
the Camera ID, PTZ driver, and Port settings� The Camera ID is necessary to control multiple cameras�
If you click Save to enable this function, the camera control panel will be displayed on the main page�
Please refer to the illustration on page 80�