Filter
Top Products
VIVOTEK - A Leading Provider of Multimedia Communication Solutions
User's Manual - 7
Hardware Reset
The reset button is used to reset the system or restore the factory default settings� Sometimes
resetting the system could set the system back to normal state� If the system problems remain
after reset, restore the factory settings and install again.
Reset: Press and release the indented reset button with a needle� Wait for the Network Camera
to reboot. The status LED will extinguish, then become steady red in normal state.
Restore: Press on the reset button continuously for over 5 seconds� Note that all settings will be
restored to factory default. The status LED will extinguish; upon successful restore, the status
LED will become steady red in normal state�
SD Card Capacity
This network camera is compliant with SDHC 16GB / 8GB and other SD cards under the
standard�
Reset button
Status LED