Appendix 86
P-5000 User’s Guide
❏ Do not use a damaged or frayed AC adapter.
❏ If you use an extension cord with the viewer, make sure the total amperage of all
devices plugged into the extension cord does not exceed the cord’s amperage rating.
❏ Never disassemble, modify, or attempt to repair the AC adapter by yourself except as
specifically explained in this guide.
❏ Do not use power outlets controlled by wall switches or automatic timers.
❏ Do not use power outlets on the same circuit as large motors or other appliances that
may cause voltage fluctuations.
❏ Avoid using outlets on the same circuit as photocopiers or air control systems that
regularly switch on and off.
❏ To prevent fire or electric shock, do not cover the AC adapter with a blanket or similar
covering.
❏ Position the viewer’s power cable so that it will not be stepped on or run over.
❏ Do not place any objects on the power cable and the AC adapter.
❏ Keep the power cable straight at the ends and at the points where it enters the
transformer.
❏ The power cable should be placed so as to avoid abrasions, cuts, fraying, crimping,
kinking, and other damage.
❏ If the AC plug does not fit your outlet, have a proper outlet installed by a qualified
electrician.
❏ Remove the AC plug from the outlet during lightning storms.
For US and Canadian users:
Use the included power cord or a 6 to 10 foot UL-approved type SPT-2 or heavier type, 2
× 18 AWG cord with a 125 V 10 A plug and 125 V 7 A connector.
When using a memory card
❏ Only memory cards designed for the viewer’s specifications can be used.
❏ Do not remove a memory card or turn off the viewer while the Access lamp is flashing.
See “Parts” (page 9) to find where the Access lamp is.
