174
Software Fixes in Release M.08.51 - M.10.72
Release M.10.42
■ SCP (PR_1000428142) — The switch does not exit a secure copy protocol (SCP) session
properly.
Release M.10.42
No Problems Resolved in Release M.10.42 (Never Released)
Release M.10.43
Problems Resolved in Release M.10.43 (Never Released)
■ CLI (PR_1000413734) — MDI/MDIX information shows "N/A" in the CLI output of the
command show int brief. It should show either MDI or MDIX.
■ Enhancement (PR_1000428642) — SNMP v2c describes two different notification-type
PDUs: traps and informs. Prior to this software release, only the traps sub-type was
supported. This enhancement adds support for informs. For more information, see “Release
M.10.43 Enhancements” on page 126.
■ Enhancement (PR_1000452407) — The Dynamic IP Lockdown feature was added for the
3400cl series switches. For more information, see “Release M.10.43 Enhancements” on page
126.
Release M.10.44
Problems Resolved in Release M.10.44 (Not a Public Release)
■ Loop Protection (PR_1000447746) — Client-based AAA stops any packets with unau-
thenticated source MAC-addresses, including BPDU's and loop-protect packets, creating
loops that can be hard to detect.
■ Crash (PR_1000456340) — The switch may crash with a message similar to the following.
No message buffers : alloc_free.c:435
■ OSPF (PR_1000453794) — Removing an IP address from a multinetted VLAN, or removing
the entire VLAN, causes the switch to stop seeing it's neighbors "Hello" packets, and,
ultimately, lose the OSPF adjacency.
■ Boot Image (PR_1000451000) — Canceling boot system flash <pri | sec> sets the default
boot image. Issuing a reload after canceling causes the switch to boot into the canceled flash
image.
