27
Enhancements
Release M.08.80 through M.08.83 Enhancements
The following shows a sample output from this new command.
Figure 2. Example rate display output for ports
Operating Notes
■ For each port on the switch, the command provides a real-time display of the rate at which
data is received (Rx) and transmitted (Tx) in terms of kilobits per second (KBits/s), number
of packets per second (Pkts/s), and utilization (Util) expressed as a percentage of the total
bandwidth available.
■ As in previous software versions, the show interfaces <port-list> command can be used to
display the current link status and the port rate average over a 5 minute period. Port rates
are shown in bits per second (bps) for ports up to 1 Gigabit, and are shown in kilobits per
second (Kbps) for 10 Gigabit ports.
Release M.08.80 through M.08.83 Enhancements
Software fixes only; no new enhancements.
ProCurve# show interface port-utilization
Port
Mode
|
|
|
-------
KBits/s
Rx
-------
Pkts/s
------
Util
-------
KBits/s
Tx
------
Pkts/s
------
Util
---- ---- + ------- ------- ------ ------- ------ ------
1 100FDx | 100000 525 12 100000 400 10
2 1000FDx | 0 0 0 0 0 0
3 100FDx | 536 44 00.53 504 0 00.50
4 1000FDx | 0 0 0 0 0 0
5 1000FDx | 0 0 0 0 0 0
6 1000FDx | 0 0 0 0 0 0
7 1000FDx | 0 5 0 0 0 0
8 1000FDx | 0 5 0 0 0 0
9 100FDx | 0 30 0 0 0 0
