Titan Tool 0533745C 0533940C 0533960C 0533975C Manual

A SERVICE OF

next previous

PowrCoat 9

GB

Operation

8. Make sure the sprayer is earthed (grounded). All sprayers are

equipped with a earthing (grounding) cable (1). Clip the end

of the grounding cable to a true earth ground.

1

9. Strain all paints with a nylon strainer to ensure trouble free

operation and freedom from frequent cleaning of the inlet

screen and gun lter.

10. Make sure the spray area is well ventilated to prevent

hazardous operation with volatile solvents or exhaust fumes.

If lacquer or other flammable materials are to be

sprayed, ALWAYS locate the compressor outside the

immediate spraying area. Failure to do so may cause

an explosion.

 11. Locatethecompressoroutsidetheimmediatesprayingarea

to avoid clogged air intake of the compressor with overspray.

4.2 Automatic Lubricator

The automatic lubricator (Fig. 10, item 1) provides lubrication to the

air that is being delivered to the system. It is set at the factory for the

correct injection rate and should not be adjusted until the reservior

needstoberelledwithAirCare™lubricant.Checkthelevelthrough

the openings (2) in the side of the air motor shroud.

After relling the reservoir, the automatic lubricator will need

adjusting. Turn the adjusting screw (1) clockwise to increase the

AirCare™injectionrateandcounterclockwisetodecreaseit.

1

2

Check the injection rate by observing the ow through the openings

in the side of the air motor shroud.

 • Theproperowrateis1dropofAirCare™perminute.

 • Incoldweatherwhenicingmayoccur,increasetheinjection

rate.