20 PowrCoat
GB
Servicing
8.2 Servicing the Fluid Pump Assembly P/N 185-551
1
2
21
3
5
6
18
14
15
19
16
7
9
8
10
10a
11
12
13
20
17
4
Use of non-Titan manufactured service parts
may void warranty.
The 185 Series Pump should receive a routine servicing after
approximately 1000 hours of use or earlier if there is excessive
leakage from the top packing, or if pump strokes become faster
on one stroke or another. The use of Titan Piston Lube Part #
314-480 is recommended as an upper packing lubricant. DO
NOTSUBSTITUTEoil, water or solvent for an upper packing
lubricant.
Disassembly Procedure
1. Test pump before disassembly. Follow test procedure in
Troubleshooting Guide - Fluid Section.
2. Loosenthefourscrewsthatsecuretheshieldassembly
totheplate.Loosenthetwoscrewsthatsecurethetwo
halves of the shield together and remove the shield.
3. Remove siphon hose assembly. Remove stanchion nuts
(1) and washers (2).
4. Hold the air motor piston rod (3) at the wrench ats and
unthread coupling nut (4) to separate pump from motor.
Never use a pipe wrench, pliers, etc. on the
chrome part of hydraulic, air or fluid section
rod.
5. Remove coupling nut (4) on connecting rod (5). Remove
connecting rod (5) from displacement rod (6).
6. For easier disassembly, unthread and remove foot valve
(7).
7. Remove PTFE O-ring (8), O-ring (9), ball cage assembly
(10) and ball (11).
8. Remove cylinder (12).
9. Remove displacement rod (6).
10. Place piston seat (13) in a vise and use a wrench on the
ats to remove the displacement rod (6) from the piston
seat (13).
11. Remove lower packing set (14), spring (15), spring
retainer (16) and ball (17).
12. Remove upper packing spring (18), packing set (19) and
O-ring (20).
13. Clean and inspect all parts. Inspect displacement rod’s
(6) and cylinder’s (12) chrome for grooves, dents or worn
areas. Replace if hard chrome is damaged. Inspect valve
seats and replace if cracked or worn.
Technical Data
Displacement Rod Area 1.38 in (8.90 cm)
StrokeLength 4 in. (10.2 cm)
DisplacementVolume/
Stroke
5.55 in (90.9 cm); 0.091 liter
DisplacementVolume/40
Cycles / 80 Strokes
444 in (7272 cm); 1.92 gal
(7.27 liter)
Motor Selection 700/900 Series
Motor Pump Ratio 30:1 (730) / 40:1 (940)
0533730W
0533730C
0533940W
0533940C