Filter
Top Products
102 M
ANAGING
THE
VCN A
CCESS
C
ONCENTRATOR
The gateway that appears is the current gateway. To change the gateway,
type the new gateway and press <Enter>.
To avoid changing the gateway, only press <Enter>.
The menu in Figure 79
re-appears. To change the network parameters
again, type
1
and press <Enter>.
To save new network parameters:
1
Ty p e
0
and press <Enter>.
The question appears:
Do you want to save changes? Y/N [N]
2
To
■
Save changes, type
y
and press <Enter>.
The messages appear:
The IP parameters were saved in a non-volatile memory.
The changes will take effect after reset
Press ENTER to continue ...
After the user resets Port 1 or the agent, the modified network
parameters take effect.
■
Discard changes, type
n
and press <Enter> n.
Close Telnet Session
Since Telnet sessions are used in remote network management, it is
possible for local and remote central management sessions to be active
simultaneously.
To close a Telnet session, type
3
in the
Agent Configuration Menu
, and
press <Enter>.
If a Telnet session does not exist, the message appears:
There isn’t any opened Telnet session
If a Telnet session exists, the message appears:
This will close the currently opened Telnet session