Filter
Top Products
Installing the VCN Access Concentrator 29
To mount the VCN AC:
1
Insert one handle into the two outermost bracket holes as shown in
Figure 13
.
Ensure that the handle is pointing outward from the unit.
Figure 13 Fitting a Bracket for Rack Mounting
2
Tighten the handle from the rear with the two screws enclosed for this
purpose, using a number 3 Phillips screwdriver (not supplied).
3
Repeat steps 1 and 2 for the second handle.
4
Match the four holes of the bracket to the four mounting holes on one
side of the VCN AC, as shown in Figure 13
.
5
Using the four screws enclosed for this purpose, screw the bracket to the
VCN AC unit.
6
Repeat steps 4 and 5 for the second bracket.
CAUTION:
You must use the screws supplied with the mounting
brackets. Damage caused to the unit by using incorrect screws invalidates
your warranty.
7
Insert the VCN AC into the 19-inch rack and secure with two suitable
screws on each side (not provided).
Ensure that ventilation holes are not obstructed.