Filter
Top Products
-
29
-
Network >> Wireless >> WPS Setting
The camera supports WPS (WiFi Protected Setup™) feature that allows your camera to connect to the
wireless network easily and safely without manually configuring the wireless security settings. Please
note that Your AP/Router must support WPS feature as well. If you are not sure, please refer to the
manufacturer’s manual of your AP/Router.
Select either PIN or PBC mode to start the WPS session:
Select PIN Mode:
Step 1 Enter the SSID of the AP/Router you wish to connect to, or click Site Survey and select
from the listed wireless networks.
Step 2 Go to the WPS section of your AP/Router’s web configuration page, then enter the PIN
Code generated by the camera (in this case, “00639392”) into the corresponding field.
Please check your AP/Router’s manufacturer’s manual for more details.
Select PBC Mode (Recommended):
Step 1 Click on the Connect button on this page or push the WPS button on the backside of the
camera.
Step 2 Push the WPS hardware button on your AP/Router or the WPS software button in the
web configuration page of your AP/Router.
Within 2 minutes, the camera will be wirelessly associated with your AP/Router.