Filter
Top Products
-
37
-
4.6 Motion Detect
*This function can only be configured in Windows Internet Explorer.
The Motion Detect menu contains the command and option that allow you to enable and set up the
motion detection feature of the camera. The camera provides two detecting areas.
To enable the detecting area, select Window 1 or 2 from the pull-down list, and then check Enable.
When the detecting area is enabled, you can use the mouse to move the detecting area and change the
area coverage.
- Name: Assign a name to the detecting area.
- Threshold: Move the slide bar to adjust the sensitivity of motion detection. Make sure the threshold
(the horizontal line) is low (sensitive) enough, such that the signal (appear when motion detected)
goes over the threshold line, and at the same time the events (i.e, emailing snapshot, FTP
uploading) you set up in Event Config are triggered.