Filter
Top Products
51
AXIS 233D - System Options
About
Third Party Software Licenses - click View licenses for a list of the licensed software used
in the AXIS 233D Network Dome Camera.
Resetting to Factory Default Settings
To reset the AXIS 233D to the original default settings, go to the System Options >
Maintenance web page (described in
Maintenance, on page 48) or use the control button
on the AXIS 233D as described below
Red Restart Button
Status LED Indicator
Black Control Button
:
Resetting to the Factory Default Settings
This will reset all parameters, including the IP address, to the Factory Default settings:
1. Remove dome of camera. See Installation Guide for instructions.
2. Press and hold the red and black button at the same time. Release the red restart button, but continue
to hold down the black control button.
3. Keep the black control button pressed until the status indicator flashes amber (this may take up to 15
seconds).
4. Release the black control button.
5. When the status indicator displays green (which can take up to 1 minute) the process is complete and
the camera has been reset to factory default.
6. Re-assign the IP address in the AXIS 233D using one of the methods described in this document.