Filter
Top Products
AXIS Q6035 PTZ Dome Network Camera
System Options
The following traps are available:
•Coldstart
•Warmstart
•Linkup
• Authentication failed
SNMP v3 provides encryption and secure passwords. To use traps with SNM P v 3, an SNMP v3 management application is required.
To use SNMP v3, HTTPS must be enabled, see
HTTPS, on page 40
. To enable SNMP v3, check the box and provide the initial user
password.
Note
The initial password can only be set once. If the password is lost, the Axis product must be reset to factory default, see
Reset to Factory Default Settings, on page 49
.
UPnP
TM
The Axis product includes support for UPnP
TM
.UPnP
TM
is enabled by default and the product is automatically detected by operating
systems and clients that support this protocol.
UPnP
TM
can be disabled under System Options > Network > UPnP
TM
.
RTP/H.264
The RTP port range and multicast settings are config u red under System Options > Network > RTP.
The RTP port range de fines the range of ports from which the video/audio ports are auto
matically selected. For multicast streams,
only certain IP a ddresses and port numbers should be used.
Select Always Multicast Video and/or Always Multicast Audio to start multicast streaming without opening an RTSP session.
Bonjour
The Axis product includes support for Bonjour. Bonjour is enabled by default and the product is automatically detected by op erating
systems and clients that support this protoc
ol.
Bonjour can be disabled under System Op
tions > Network > Bonjour.
Storage
SD Card
NOTICE
To prevent corruption of recording s, the SD card should always be unmounted before it is ejected.
The Axis product supports SD cards with the following file systems:
• ext4 — recommended due to its resilie nce against data loss if the card is ejected or if there is abrupt power loss. To access
data stored on the card from the Window s operating system, a third-party ext4 driver or application is required.
• vFAT — most SD cards are p re-formatted with vFAT when purchased.
If required , the SD card can be re- formatted to the desired file system. To for mat the SD card:
1. Insert the SD card in the SD card slot.
2. Go to System Options > Storage and click SD Card.
46