Filter
Top Products
Camera Browser Interface Operation via the browser | en 17
Bosch Security Systems Software manual AM18-Q0605 | v5.0 | 2011.07
Pre-position
To move the camera to a pre-position, click one of the buttons
numbered one to six.
To store the current position of the camera in a pre-position:
1. Position the camera.
2. Enter a pre-position number.
3. Click Set.
3.1.4 Digital I/O
Depending on the configuration of the unit, the alarm input and
the relay output are displayed next to the camera image.
The alarm symbol is for information and indicates the input
status of the alarm input:
– Active 1 = Symbol lights
– Active 0 = Symbol not lit.
The camera relay allows the operation of an external device (for
example, a light or a door opener).
To operate, click the relay symbol.
– The symbol is red when the relay is activated.
3.1.5 System Log / Event Log
The System Log field contains information about the operating
status of the camera and the connection.
Events such as the triggering or the end of alarms are shown in
the Event Log field.
To view, filter and save these messages to a file, click
in the top right-hand corner.
To clear the log, click in the top right-hand corner of
the relevant field.