Filter
Top Products
84 en | Interfaces Camera Browser Interface
AM18-Q0605 | v5.0 | 2011.07 Software manual Bosch Security Systems
14 Interfaces
14.1 Alarm input
Configure the alarm triggers for the camera.
Select N.C. (Normally Closed) if the alarm is to be triggered by
closing the contact.
Select N.O. (Normally Open) if the alarm is to be triggered by
opening the contact.
14.1.1 Name
Enter a name for the alarm input. This is then displayed below
the icon for the alarm input on the LIVEPAGE (if configured).
14.2 Relay
Configure the switching behavior of the relay output.
Select different events that automatically activate an output.
For example, turn on a floodlight by triggering a motion alarm
and then turn the light off again when the alarm has stopped.
14.2.1 Idle state
Select Open for the relay to operate as an N.O. contact, or
select Closed if the relay is to operate as an N.C. contact.
14.2.2 Operating mode
Select the way the relay works.
14.2.3 Relay follows
Select the event that triggers the relay.
Interfaces
> Alarm input
> Relay
> COM1