Filter
Top Products
High Speed Pan/Tilt System Installing the High Speed Pan/Tilt | en 15
Bosch Security Systems Instruction Manual F01U.073.990 | Version 1.0 | 2007.07
4.3 Connecting the Power Supply
The base with power supply box is available in two (2) power supply voltages (24 VAC or
230 VAC). Before proceeding with the installation, check the identification label of the prod-
uct to verify that the device coincides with the power supply requirements.
When the base is opened, the power supply board appears as shown below. To connect the
power supply, make the connections as seen in Figure 4.7.
Fig. 4.7 Connecting the Power Supply
To wire the power cable (not supplied), use Table 4.2 to attach the appropriate colored wire
to the appropriate terminal.
Table 4.2 Terminal Connections
!
CAUTION!
When connecting the base, make sure the power supply is disconnected and
that the disconnecting switch is open.
Wire Color 24 VAC Terminal Connection
Per local Installer Neutral
Per local Installer Live/Active
Green/Yellow Earth
Wire Color 230 VAC Terminal Connection
Blue Neutral
Brown Live/Active
Green/Yellow Earth
Power Supply and Bi-polar Disconnecting Switch