Cannon XL H1 a Camcorder User Manual


 
37
Recording
Low-angle Recording
The carrying handle is equipped with a duplicate set
of recording and zoom controls, ideal for low-angle
recording. Slide the LOCK switch in the direction of
the arrow to prevent the accidental operation of
these controls.
Power Saving Mechanisms
STANDBY Button
Press the STANDBY button and hold it pressed down for more than 1 second in record pause or VCR stop
mode to enter the standby mode. The message “ENTERING “POWER STANDBY”” will be displayed before
the camcorder enters the standby mode. In standby mode, power will be shut down to the camera and
recorder sections but camera settings (including exposure lock and color bars settings) will be retained.
Press the STANDBY button again to turn the camcorder on.
Power Save Function
In order to protect the tape and video heads, the camcorder will enter the power save mode (VCR stop) after
4 minutes 30 seconds in record pause mode. If left 30 more seconds without any operation, the camcorder
will automatically shut off. Turn off the power save function with [SYSTEM SETUP] [POWER SAVE] setting
( 136) if you wish to make adjustments without worrying about losing your settings as a result of the
automatic shut-off.
Once the camcorder entered the power save mode, press the Start/Stop button to start recording or press
one of the custom keys ( 79) to which the [VCR STOP] function was assigned, to return to record pause
mode. If the camcorder automatically shut off (after 5 minutes), turn the dial to OFF and then back to
one of the recording programs.
VCR Stop Function
You can assign the [VCR STOP] function to either custom key ( 79). In VCR stop mode the camcorder is
only partially turned off: The camera section is powered normally while the recorder section is shut off. When
you press the assigned custom key, you can make adjustments to the camera section as long as necessary
without worrying about the 5-minute shut-off timer of the power save function. To return to record pause
mode, press the assigned custom key again.
Zoom lever
LOCK switch