Filter
Top Products
28
Load a fully-charged Battery Pack LP-E10 into the camera. The card
(sold separately) can be an SD, SDHC, or SDXC memory card. The
captured images are recorded onto the card.
Make sure the card’s write-protect switch is set upward to
enable writing/erasing.
1
Open the cover.
Slide the lever as shown by the
arrows and open the cover.
2
Insert the battery.
Insert the end with the battery
contacts.
Insert the battery until it locks in
place.
3
Insert the card.
As shown in the illustration, face
the card’s label side toward the
camera back.
Insert the card straight in all the way.
4
Close the cover.
Press the cover until it snaps shut.
When you set the power switch to
<
1
>, the number of possible shots
(p.32) will be displayed on the LCD
monitor.
Installing and Removing the Battery and Card
Installing the Battery/Card
Write-protect switch
COPY