Filter
Top Products
29
Installing and Removing the Battery and Card
1
Set the power switch to <2>.
(p.31)
2
Open the cover.
Make sure the access lamp is off,
then open the cover.
If “Recording ...” is displayed, close
the cover.
3
Remove the battery.
Press the battery release lever as
shown by the arrow and remove the
battery.
To prevent short circuiting of the
battery contacts, be sure to attach the
protective cover (provided, p.26) to
the battery.
4
Remove the card.
Gently push in the card, then let go.
The card will stick out.
Pull the card straight out.
5
Close the cover.
Press the cover until it snaps shut.
Removing the Battery/Card
After opening the card/battery compartment cover, be careful not to push it
back further. Otherwise, the hinge might break.
The number of possible shots depends on the remaining capacity of the
card, image-recording quality, ISO speed, etc.
Setting [1 Release shutter without card] to [Disable] will prevent you
from forgetting to insert a card (p.154).
COPY