Filter
Top Products
Wi-Fi Functions 169
4 Touch the [Encryption Key] control button to enter the encryption
key or password of the wireless access point and then touch [OK].
• If the encryption method of the wireless access point is set to WEP,
the WEP index key will appear on the screen. Select the same index
key of the access point.
5 Touch [Automatic] to automatically obtain an IP address.
• To assign the IP address manually, touch [Manual] and perform the
procedure in To manually assign an IP address (A 167).
• A screen to test the settings will appear.
6 Select whether to test the settings.
• You can touch [Check Current Configuration] to review the network
settings.
• If you touched [Yes], a test of the settings will be performed and a
confirmation screen will appear. Touch [OK].
7 Save the settings of the connection point.
* After touching [OK], you can review the network settings. Touch [Wi-Fi Setup]
> [Check Current Configuration] > Desired connection point > [Î] or [Í]
> [K] three times when finished.
To manually enter a wireless access point (step 3)
Enter the details of the wireless access point.
* If you select [Open], you can select [No Encryption] or [WEP]. If you select,
[Open] > [WEP] or [Shared Key WEP], you will need to specify the WEP index
key.
[Yes] > [OK]* > [X]
Enter the access point’s SSID > [OK] > [OK] > Enter
the authentication/encryption method* and, if applicable,
the encryption key of the access point > [OK] >
Continue to step 5
COPY