Filter
Top Products
Additional Information
112
The lens cover is not fully closed. Turn the camcorder off, then on again.
- The lens cover did not close completely when you set the camcorder to a playback mode. Turn the camcorder
off and then on again. If the problem persists, contact a Canon Service Center.
The lens cover is not fully open. Turn the camcorder off, then on again.
- The lens cover did not open completely when you set the camcorder to a recording mode. Turn the camcorder
off and then on again. If the problem persists, contact a Canon Service Center.
This photo could not be deleted
- Protected photos ( ) cannot be deleted. Remove the protection ( 70).
This photo cannot be displayed
- You may not be able to display photos taken with other devices or image files created or edited on a computer.
Too many photos. Disconnect the USB cable.
- Disconnect the USB cable. Try using a memory card reader or decrease the number of photos on the memory
card (Windows: fewer than 1,800 photos, Macintosh: fewer than 1,000 photos). If a dialog box appeared on
the computer screen, close it and then reconnect the USB cable.
Transfer order error
- You attempted to set more than 998 transfer orders. Reduce the number of photos marked with transfer
orders.
Unable to recognize the data
- You transferred data to the camcorder recorded in a different television system (PAL or SECAM).
Unable to recover data
- Could not recover a corrupted file.
- This message can also appear if condensation has formed ( 121). Wait until the camcorder dries
completely before resuming use.
Messages Related to the Optional DW-100 DVD Burner
If an error message appears while the camcorder is connected to the optional
DW-100 DVD Burner, refer to the following section and also to the instruction manual
of the DVD Burner.
Cannot read the disc. Check the disc.
- During disc recording mode, this message can appear when a commercially available DVD disc (a DVD disc
containing movies, software, etc.) or an 8 cm mini DVD disc is inserted.
- During disc playback mode, this message can appear when a commercially available DVD disc or a brand
new DVD disc is inserted.
Close the memory card slot cover
- The memory card slot cover is open. Close the cover after correctly inserting the memory card ( 32).
Connect the compact power adapter
- The camcorder is being powered by the battery pack. Connect the compact power adapter to the camcorder.
Disc access failure. Check the disc.
- There was an error when reading the disc or attempting to write onto it.
- This message can appear also if condensation has formed ( 121). Wait until the DVD burner dries
completely before resuming use.
COPY