Filter
Top Products
108
Creating Backup Copies of your DVD
You can create a backup copy of your finalized disc on a common (12 cm) DVD disc.
Even if your computer does not have a DVD drive with writing capabilities, you can use
the camcorder itself to create a backup disc on an 8 cm Mini DVD disc.
1. Connect the camcorder to the computer and run MyDVD for Canon as
previously described ( 106).
2. Insert a finalized disc in the camcorder and load a brand new media in
your computer’s DVD drive.
• To make a copy of a DVD-RW recorded in VR mode, load a blank DVD-RW in your
computer’s DVD drive. To make a copy of a DVD-R or DVD-RW recorded in VIDEO
mode, you can load a blank DVD-R or DVD-RW.
• You can also use a fully erased DVD-RW disc instead of a brand new media.
However, depending on the condition of the disc, the operation will take longer. To
fully erase a DVD-RW disc you will need DVD authoring/mastering software (for
example Roxio Record Now!) installed in your computer.
3. Click on the “Make a Backup DVD” option in the New Project tab.
4. Select the camcorder as the “Device to read from”.
5. Select the computer’s DVD drive (with writing capabilities) as the
“Device to write to”.
If your computer is not equipped with a DVD drive with writing capabilities, select the
camcorder also as the “Device to write to”.
6. Click on the “Copy” button and follow the indications on the screen.
• When the “Your disc was created successfully” screen appears, click on “OK” to
finish the task and eject the backup disc.
• When the “Please insert a blank or rewritable DVD into the DVD drive” dialog box
appears, if the tray of a DVD drive other than the one selected in step 5 is ejected,
click on “Cancel” and start again from step 4. If this problem occurs, if the source
disc is a DVD-RW disc, some recordings on the source disc might be lost.
If you create a backup copy of a disc containing only still images, the backup
copy cannot be read with the camcorder.
Recordings made in LP mode in Widescreen (16:9 aspect ratio) on a DVD-RW
that was initialized in VR mode cannot be transferred to the computer.
We recommend powering the camcorder from a household power outlet while it
is connected to the computer.
The time required to complete the backup copy will vary depending on the
scene recording conditions and the amount of free space remaining on the
source disc.
Finalized DVD discs created with MyDVD for Canon cannot be unfinalized
using the camcorder.
For further details about restrictions when using MyDVD for Canon, refer also to
the “README” section in the software’s help modules.