Filter
Top Products
Chapter 3 Shooting 49
Chapter 3 Shooting
4 Release the REV or FWD button when you find
the tape location where you wish to continue
shooting.
The DSR-1/1P enters recording pause mode.
5 Press the VTR button on the camera head or the
lens.
The DSR-1/1P starts recording.
Using the Freeze Mix Function
The freeze mix function superimposes a freeze-frame
image of a previously recorded shot on the shooting
image displayed on the viewfinder screen.
You can use this function to easily frame a subject
within the same framework from a previous shot.
Note
When the camera head is in EZ mode, the freeze mix
function is disabled. Release the EZ mode beforehand.
(See page 14.)
1 Dock the DSR-1/1P to the camera head and
connect a color monitor to the MONITOR OUT
connector.
2 Perform steps 2 to 10 from “Basic Procedure for
Shooting” (page 43).
3 Play back the tape on which the image to be used
for framework alignment has been recorded.
For playback operation, refer to the operating
instructions for the DSR-1/1P.
4 Press the MENU/STATUS switch down.
The following indication appears on the screen.
PLAY
c
FREEZE MIX(ON
c
v)
EXIT MENU (YES
c
v)
5 Press the UP/ON button when you see the image
you want to freeze.
The frozen playback image is displayed, mixed
with the shooting image, in monochrome. The
indication “FREEZE MIX ON” appears on the
screen.
FREEZE MIX ON
MIX OFF (YES
c
v)
To release the freeze mix mode, press the UP/ON
button again.
To change the freeze-frame image
Press the DSR-1/1P’s PLAY button.
This returns to the screen shown in step 3 above,
and color playback mode begins.
Use the DSR-1/1P’s tape transport buttons to find
the desired image and then perform steps 4 and 5
again.
6 Once you have framed your subject, press the UP/
ON button to cancel the freeze function.
7 Find the recording start point or insert a new
cassette for recording, then begin recording.
Note
If you use the DSR-1/1P’s tape transport buttons
during back space editing, the back space editing mode
will be stopped. When you were using the ClipLink
function when shooting, If you simply restart the
recording you will lose any ClipLink data that was
recorded. To avoid this, press the DSR-1/1P’s
ClipLink CONTINUE button before restarting
recording.
For details, see the operating instructions for the DSR-1/1P.