Filter
Top Products
Appendix 97
Appendix
Warning indications
Continuous Flashing once per second Flashing four times per second
Four beeps per second One beep per second Continuous
For the warnings appearing in the viewfinder when a VTR is connected, see the section “Viewfinder Normal Indications” (page
54).
Warning Indications
If a fault occurs during operation, a warning is given
by the REC/TALLY and BATT indicators in the
viewfinder and the tally lamp lighting or flashing, and
also by warning indications on the viewfinder screen.
When you are using a DSR-1/1P or PVV-3/3P, the
WARNING indicator on the VTR also lights or
flashes, and warning indications appear in the display
window. There is also a warning tone in the earphone.
Camera
REC/
TALLY
indicator
and tally
lamp
What to do
BATT
indicator
Viewfinder
screen
indication
VTR
WARNING
indicator
Display
window
Warning tone
Fault VTR action
Carry out head cleaning,
referring to the instruction
manual for the VTR. If the
problem persists after cleaning
the heads, disconnect the
power and consult your Sony
dealer.
—— RF
(during
recording
only)
(During
recording only)
The video
heads are
clogged, or
there is some
other fault in
the recording
system.
The VTR emits
a warning tone
when it detects
head clogging.
Disconnect the power and
consult your Sony dealer. (The
SERVO indication may flash
momentarily when the tape
transport starts, but this does
not indicate a problem.)
— — SERVO The servo
lock has
been lost.
Recording
continues, but
the recording
may not be
satisfactory.
Stop the tape transport. Wait
until the HUMID indication
does not appear when you
power the unit on.
— — HUMID There is
condensation.
Press the EJECT button to
eject the cassette. Close the
cassette compartment and
check that the top panel has
descended before powering
off. Then consult your Sony
dealer. (Do not attempt to
insert any cassette.)
SLACK——
— — TAPE
(flashing,
during
recording
only)
The tape is
near the end.
Change the cassette if
necessary.
— — TAPE
(flashing)
The tape is at
the end.
Change the cassette.
BATT
11.0V
BATT
(flashing)
The battery is
almost
exhausted.
Change the battery when
possible.
Recording
continues, but
if the tape
sticks to the
drum,
recording
stops.
Playback,
rewind, or fast
forward stops.
The operation
stops. (Refer
to the service
manual or
maintenance
manual.)
Operation
continues.
Recording,
playback, and
fast forward all
stop.
Operation
continues.
(During
recording
only)
(During
recording)
BATT
10.5V
BATT
(flashing)
The battery is
exhausted.
Change the battery.
Operation
continues.
The tape is
not wound
properly.
(During
recording)
(During
playback,
rewind, or fast
forward)