Filter
Top Products
Additional Information
96
CANNOT RECORD MOVIES ON THIS CARD INITIALIZE USING ONLY THE CAMCORDER
- The memory card in the camcorder was initialized using a computer. Initialize the memory card with this
camcorder ( 29).
CARD FULL
- The memory card is full. Erase some recordings ( 40, 62) to free some space or replace the memory card.
// CARD REACHED THE MAXIMUM NUMBER OF SCENES
- The memory card already contains 3,999 scenes (the maximum number of scenes); no further scenes can be
copied onto the memory card. Delete some recordings ( 40) to free some space.
CARD UNABLE TO RECOGNIZE THE DATA
- The memory card contains scenes recorded in a different television system (NTSC).
CHANGE THE BATTERY PACK
- Battery pack is exhausted. Replace or charge the battery pack ( 17).
CHECK THE CARD
- Cannot access the memory card. Check the memory card and make sure it is inserted correctly ( 28).
- A memory card error occurred. The camcorder cannot record or display the image.
- If after the message disappears, appears in red, perform the following: Turn off the camcorder and
remove and reinsert the memory card. If turns back to green you can resume recording/playback.
- Initialize the memory card ( 29). (Doing so will erase all the recordings on the memory card.)
CONNECT THE COMPACT POWER ADAPTER
- When the camcorder is in mode and is connected to the computer, this message will appear if the
camcorder is being powered by the battery pack. Connect the compact power adapter to the camcorder.
COULD NOT ADD TO PLAYLIST
- The playlist cannot contain more than 100 hours of scenes.
CARD INITIALIZE USING ONLY THE CAMCORDER
- There is a problem that prevents accessing the memory card. Initialize the memory card with this camcorder
( 29).
LCD SCREEN HAS BEEN DIMMED
- Hold pressed down for 2 seconds or more.
MAY NOT BE POSSIBLE TO RECORD MOVIES ON THIS CARD
- You may not be able to record movies on a memory card without a Speed Class rating. Replace the memory
card with one rated Speed Class 2 or higher.
NAMING ERROR
- The folder and file numbers have reached their maximum value. Set [PHOTO NOS.] to [RESET] ( 87) and
erase all the photos on the memory card or initialize it.
NEED TO RECOVER FILES FROM THE CARD. CHANGE THE POSITION OF THE CARD'S LOCK SWITCH.
- This message will appear the next time you turn on the camcorder if power supply was accidentally
interrupted while the camcorder was writing to the memory card and later the position of the card's LOCK
switch was changed to prevent erasure. Change the position of the LOCK switch.
NO CARD
- There is no memory card in the camcorder.
DISP.
COPY