Filter
Top Products
36 Photo Printing from Printed Photo or Film
4 Lift the Document Cover, remove the FAU Protective Sheet from the Document
Cover, and then remove the Film Guide (A) from the rear of the FAU Protective
Sheet.
5 Mount film in the Film Guide and load it on the Platen Glass.
z Mounting a 35 mm Film Strip:
(1) On the Film Guide (B), open the Film Holder
(C).
Squeeze the edges of the Film Holder inward
lightly to release it.
(2) Mount the film in the Film Strip Frame on the
Film Guide with the front side (the side
showing the correct image) facing down, and
with the frame order running from left to right.
Set the tip of the film under the tabs of the Film
Strip Frame and position the film so that the
separation lines between frames are aligned
with the white line marks of the Film Holder.
(3) Squeeze the edges of the Film Holder inward
lightly and close it completely.
Note
Put your finger on the hinge part (D) of the
Film Strip Frame (E) so that it does not come
off the Film Guide when opening the Film
Holder.
Note
Depending on the films, the separation lines
between frames may not be aligned with the
white line marks of the Film Holder when you
set the tip of the film under the tabs of the Film
Strip Frame. In this case, give priority to
aligning the separation lines between frames
with the white line marks.
(A)
(A) Film Guide
(E)
(B) (C)(D)
(2)
(3)