Filter
Top Products
If the LCD monitor (or viewfinder) displays the Date/Time menu when
you turn on the camera, this means that the date battery has run down
and the clock has stopped running. Please purchase a replacement
battery (lithium coin battery CR1220) and install it as follows.
The date battery is preinstalled at the factory and may
therefore expire earlier than its rated lifespan after the camera
has been purchased.
1 Turn offthe power and open the battery cover
(Basic Guide p. 1).
2 Remove the AA-size batteries,
then pull out the battery holder
by hooking your fingernail under
the bottom of the battery holder
edge.
3 Remove the old date battery and
place a new date battery into the
date battery holder with the
positive terminal (+) facing
upward.
_ Positive
terminal
4 Replace the date battery holder, replace the AA-size
(D
batteries and close the battery cover. ._
5 Set the date and time when the Date/Time menu is _"
displayed on the LCD monitor (or viewfinder) (Basic
Guide p. 4).