Filter
Top Products
Detail Settings
On-board File System Information
The On-board File System displays the used
space, free space and capacity (used space
+ free space) in bytes.
Slot A/B
If a PC card, used for communications and
storage, is inserted into the slot, the
“Manufacturer” and “Product Information” is
displayed. Depending on the card type and
its status, the operation buttons are
displayed and the card status can be
controlled. The card slots are labelled A and
B from the bottom upwards (→ P.23).
Recorded Picture Information and
Manipulation
This section displays the status of recorded
picture processing and the number of
recorded pictures. The maximum number of
pictures that can be recorded is 30,000.
Under certain circumstances, the “Rebuild”
button for “Rebuilding of recorded picture
list” and the “Delete” button for “Deletion of
recorded pictures” may be displayed, and if
the pictures cannot be recorded the reason
will be displayed.
“Rebuilding of recorded picture list”
Normally, there is no need to reconstruct
the picture list. Click “Rebuild” button if you
have removed a memory card and
modified the content of that memory card
(erased files, etc.) on another PC.
“Deletion of recorded pictures”
Deletes pictures recorded on a card.
Specify the delete criteria below and then
click the “Delete” button.
“Time”
Select the period of time following the
recording of the pictures after which the
pictures are deleted.
“Event”
Select whether the pictures to be deleted
are those where recording was performed
in response to inputs from an external
device, according to a schedule or motion
detection.
“Camera”
Select camera by which the pictures were
recorded.
You can also select a combination of
Time, Event and Camera.
Miscellaneous
“View Current Settings”
Displays a list of current settings.
“Reboot”
Reboots the VB150.
“Restore Settings”
All but the System settings and Network settings will be
restored to the factory default settings. Click “Restore”-
“OK” buttons and the VB150 will be rebooted
automatically.
Administration Tools Settings Page
Click the [Cancel] button to exit from this page. This returns you to the
settings title page.
59
e
Tip
● We recommend that you make a note of current server settings before you
restore the default settings in “Restore Settings” (→ P.114, 115).
● While the factory defaults reset switch can also be used to restore the
factory default settings, note that this resets all the settings (→ P.112).