Filter
Top Products
8-5
Appendix
Restoring the Factory Default Settings
Note
If you click the “OK” button at this point, it will not possible to abort the process to
restore the default settings. Click the “Cancel” button if you do not wish to restore the
default settings.
4. The VB-C10/VB-C10R’s factory default settings are restored.
Settings other than network-related settings such as the VB-C10/VB-C10R’s IP address, subnet
mask, and default gateway address are returned to factory default settings.
RESET
CANON INC.
MADE IN JAPAN
Tested To Comply
With FCC Standards
FOR HOME OR OFFICE USE
THIS CLASS B DIGITAL APPARATUS MEETS ALL
REQUIREMENTS OF THE CANADIAN INTERFERENCE
-
CAUSING EQUIPMENT REGULATIONS.CET APPAREIL
NUMÉRIQUE DELA CLASSE B RESPECTE TOUTES
LES EXIGENCES DU RÈGLEMENTSUR LE MATÉRIEL
BROUILLEURDU CANADA.
VB
-
C10
0123456789
000085228000
Note
If the Reset switch is pressed and all factory default settings are restored, the VB-C10/
VB-C10R’s network-related settings such as IP address, submask, and default
gateway address are all also returned to the factory default settings, making it
impossible to operate the VB-C10/VB-C10R from a PC connected to it. Use “VBIPI.exe”
on the supplied CD-ROM to set an IP address appropriate to the environment you
will be using (→ P.3-3).
If the IP Address and Password are Unknown
If the VB-C10/VB-C10R’s IP address or administration password are not known or have been
forgotten, the VB-C10/VB-C10R cannot be operated over a network. In this case, press the Reset
switch at the bottom of the unit.
1. Hold the Reset switch while you turn the VB-C10/VB-C10R’s power switch off
and then on again.
The Reset switch is located toward the rear on the bottom. Use a thin tipped object such as
the end of a paper clip to press the Reset switch.
See page 2-4 “Turning the Power ON and OFF” for procedures on how to turn OFF and ON
the VB-C10/VB-C10R’s power switch.
2. Hold the Reset switch for more than 5 seconds even after the power switch is
turned ON.
All settings in the VB-C10/VB-C10R will be returned to the factory default settings.