Filter
Top Products
3-9
Setup Procedures
System/Network Settings Page
This page is used to make Ethernet and password settings for the administrator.
Detail Settings
Note
● Assign a fixed IP address to the VB-C10/VB-C10R.
● For system security reasons, we recommend that you change the root account at
regular intervals.
● If you have forgotten the password, press the Reset switch and restore the factory
default settings (→ P.8-5).
Click the “OK” button to change the settings. To discard the changes, click the “Cancel”
button. This returns you to the settings title page.
Ethernet
“IP Address”
Enter the IP address you want to assign to VB-C10/VB-C10R.
“Subnet Mask”
Enter the subnet mask specified for the network to be
connected.
“Default Gateway Address”
Set this item when you want to connect to a different
segment within the Intranet or a wide area network such as
the Internet.
*Contact the network administrator for the IP address,
subnet mask, and default gateway address settings.
Root Account
“Password”
Set the password here. Up to 8 alphanumeric characters,
including upper- and lower-case letters, hyphens and
underscores, can be used.
“Confirm Password”
Enter the same password as above to confirm it.