Filter
Top Products
3-2
Preparations for Initial Setup
Installation Procedure
1. As shown in the diagram above, the VB-C10/VB-C10R is connected to a PC via a
hub and LAN cables (10Base-T/100Base-TX).
Once the initial setup has been completed and operation has been verified, the VB-C10/VB-C10R
can be used immediately. The diagram below shows an example of P2P connection between
the VB-C10/VB-C10R and a PC.
Note
At this stage, please do not connect the AC adapter to the VB-C10/VB-C10R yet.
2. Perform initial settings on the VB-C10/VB-C10R. (→ next page)
3. Check operation (→ P.3-6).
LAN cable
VB-C10
Hub
Installation Example
Note
Check to be sure Internet Explorer 4.01 or later has been installed.