Filter
Top Products
42
Step 6: Specify Remote Hosts and Networks.
Identify hosts and networks at the remote site to be allowed to use this IPSec tunnel to communicate
with the local hosts and networks you identified in Step 5. Add or remove hosts and networks
dynamically by clicking Add or Delete respectively. In the current scenario, for ASA 1, the remote
network is Network B (10.20.20.0), so traffic encrypted from this network is permitted through the
tunnel.
To specify a remote host or network to be allowed access to the IPSec tunnel, perform the following
steps:
1. Click IP Address.
2. Specify whether the interface is inside or outside by choosing one interface from the Interface
drop-down menu.
3. Enter the IP address and mask.
4. Click Add.
5. Repeat Step 1 through Step 5 for each host or network that you want to have access to the tunnel.
6. Click Next to continue.