Filter
Top Products
48D-Link DCS-7110 User Manual
Conguration
• Refresh: Click this button to refresh all current connections.
• Add to deny list: You can select entries from the Connection Status list and add them to the Deny
List to deny access. Please note that the selected connections will only be disconnected temporarily
and will automatically try to re-link again (IE Explore or Quick Time Player). If you want to enable the
denied list, please select Enable access list ltering and click Save in the rst column.
Disconnect: If you want to break off the current connections, please select them and click this button.
Please note that those selected connections will only be disconnected temporarily and will automatically
try to re-link again (IE Explore or Quick Time Player).
Enable Access List Filtering: Select this item and click Save if you want to enable the access list
ltering function.
Filter Type
Select Allow or Deny as the lter type. If you choose Allow Type, only those clients whose IP addresses
are on the Access List below can access the camera, and the others cannot access. On the contrary,
if you choose Deny Type, those clients whose IP addresses are on the Access List below will not be
allowed to access the camera, and the others can access.
Filter
Then you can add a rule to the following Access List. Please note that the IPv6 access list column will
not be displayed unless you enable IPv6 on the Network page. For more information about IPv6 Setting,
please refer to Enable IPv6 for detailed information.
There are three types of rules:
Single: This rule allows the user to add an IP address to the Allowed/Denied list.
Network: This rule allows the user to assign a network address and corresponding subnet mask to the
Allow/Deny List.
Range: This rule allows the user to assign a range of IP addresses to the Allow/Deny List (This rule is
only applied to IPv4).
Administrator IP address
Always allow the IP address to access this device: You can select this item and add the Administrator’s IP
address in this eld to make sure the Administrator can always connect to the device.