Filter
Top Products
9. Use IE Browser to watch IP-cam image (wireless mode)
10. If you can find camera in IP-EDIT list and see camera video from IE, than mean is
your camera wireless setup complete, when camera in wireless mode, IP-Edit
software can’t change any setting, you must use IE into setup page to change
camera setting.
11. Configuration page -> Network -> Disable LAN
12. Remove LAN Cable from camera RJ-45 connector and select
“Reboot Immediately” button for reboot again (wait 60 sec)
13. Use IE Browser to watch IP-cam image (wireless mode)
NOTES: If you can’t find camera in IP-EDIT list , than mean is something wrong, you
need use reset button to reboot camera and setup again (from step 1).
Use Pin to press Reset button 10 sec, than camera will reboot
LAN Only WLAN Only LAN+WLAN
Use IP-EDIT change setting OK OK Can’t setting
Motion detect than send image via
E-Mail
OK OK
Send Email by
LAN
Motion detect than send image via
FTP
OK OK
Send FTP by
LAN
NTP Server Support OK OK By LAN
PPPoE OK X X
2-3. Connecting to an Access Point (AP)
Your 802.11g USB 2.0 USB dongle also enables a group of wireless stations to
communicate with each other. It acts as bridging functions between the wireless network
and the wired LAN network.
e.g.
ASCII : [0~9] [A~Z] [_] , 64bit/5 charter,128bit/13 charter
12