Filter
Top Products
User’s Manual
2.2 Switch Definition
First of all, configuring the dome ID and communication protocol is required before
connecting the dome camera to other devices. The switches used for configuring these
settings are located on the bottom of the dome camera.
Indoor Dome
A
Reserved
B
RS-485 Setting
C
Dome ID Setting
D
Dome Control Protocol
E
N/A
F
22-Pin Connector
2.3 RS-485 Setting
The RS-485 setting default is half-duplex, please do not change without qualified
specialist or supplier’s RS-485 is the interface that communicates the dome camera and
its control device; for this reason, the RS-485 setup of the dome and the control device
must the same. The RS-485 default setting is half-duplex.
RS-485 Communication
9