Filter
Top Products
User’s Manual
Half-duplex
Full-duplex
2.4 Dome ID Setting
Use the switch to change your speed dome ID by turning the arrow to the desired
number respectively. For instance, if the dome ID is 123, the ID switch should be set as
below.
NOTE: No two domes should be given the same ID, or communication conflict
may occur.
Centesimal decimal single digit
NOTE: The number “0” should locate upwards as shown in above diagram for
correct switch definition.
2.5 Dome Control Protocol
Protocol is a specific set of rules, procedures used for data communications. Basing on
the devices of your surveillance system and define the protocol you are going to use.
Generally, use one protocol even the devices are provided from different manufacturers.
Use the switch to set your dome control protocol and the baud rate. Refer to below table
and turn the arrow to choose a protocol for your speed dome.
Switch No. Protocol Baud Rate
00
VCL 9600
01
Pelco D 2400
02
Pelco P 4800
04
Chiper 9600
05
Philips 9600
Pin 3
Termination
Pin 4
Line Lock
Pin 5
Set Factory Default
Pin 6
Reserved
10