Filter
Top Products
Safety Instructions
1
Safety Instructions
Safety Instructions
Read all of the instructions in this section when setting up and
using this product.
When choosing a place for this product
❏ Avoid places subject to rapid changes in temperature and
humidity. Also, keep this product away from direct sunlight,
strong light, and heat sources.
❏ Avoid places subject to dust, shocks, and vibrations.
❏ Leave enough room around this product to allow for sufficient
ventilation.
❏ Place this product near a wall outlet where the plug can be easily
unplugged.
❏ Place this product on a flat, stable surface that extends beyond this
product base in all directions. If you place this product by the wall,
leave more than 10 cm between the back of this product and the
wall. This product will not operate properly if it is tilted at an angle.
❏ When storing or transporting this product, do not tilt it, stand it on
its side, or turn it upside down; otherwise, ink may leak from the
cartridge.
❏ Leave more than 22cm between the base of this product and the
edge of the surface it is setting on; otherwise, this product may fall
if tipped forward possibly causing injury.
When choosing a power source
❏ Use only the type of power source indicated on the label on the back
of this product.
❏ Be sure your AC power cord meets the relevant local safety
standards.
❏ Do not use a damaged or frayed power cord.
❏ If you use an extension cord with this product, make sure that the
total ampere rating of the devices plugged into the extension cord
does not exceed the cord's ampere rating. Also, make sure that the
total ampere rating of all devices plugged into the wall outlet does
not exceed the wall outlet's ampere rating.
❏ If you plan to use this product in Germany, the building installation
must be protected by a 10 or 16 amp circuit breaker to provide
adequate short-circuit protection and over-current protection for
this product.