Filter
Top Products
21
2
20
Using the viewfinder or LCD monitor, frame your
shot so that the subject fills the entire AF (Auto
Focus) frame.
●
!
If the subject is not in the AF frame, use AF/AE lock
to take the picture (➡P.25).
●
!
In dimly lit scenes where the subject is difficult to see
using the LCD monitor, use the viewfinder to take
the picture.
●
!
Shooting using LCD monitor is recommended when
you want to do accurate adjustment of the range to
be shot.
●
!
When the shot is taken, the date displayed on the
LCD monitor disappears for roughly 3 seconds. The
date cannot be displayed continuously.
6
When you are using the viewfinder to take a
picture at a distance of 0.8 to 1.5 meters (2.6 to
4.8ft), only the shaded area in the figure is
photographed.
4
●
!
The zoom bar display goes off after 3 seconds.
●
!
The lens on the FinePix1400 ZOOM is a 3✕zoom
lens with a focal range equivalent to 38-114mm on a
35mm camera.
Ensure that your fingers or the camera strap do
not obscure the lens, flash, or flash control
sensor.
3
AF Frame
AF Frame
LCD Monitor
Finder
E
TAKING PICTURES
To zoom in on the subject (TELEk), press the
“a” side of the “ab” button. To zoom out
(WIDEl ), press the “b” side of the “ab”
button. A “zoom bar” is displayed on the LCD
monitor.
The optical zoom operates within this range.
●
Flash range
Wide-angle : 0.2m to 3.5m (2.6ft-11.5ft)
Telephoto : 0.8m to 3.5m (7.9in-11.5ft)
●
!
Check that the lens clean. If it is dirty, clean the lens
as described on P.73.
●
!
The image will be blurred if the camera moves when
you take the picture (camera shake).
5