Filter
Top Products
6.3.1 CLEAR command
This command initializes the scanner and can be issued at any time.
Byte 1
CNT
Byte 2
CMD
Byte 3
TEXT
X©03π X©44π Details on CLEAR command
CLEAR command details
7 6 5 4 3 2 1 0
LSB
00: Power>on clear
This command resets the system to the
power>on status.
01: Control register clear
This command initializes the operation
mode, image processing mode, and
subwindow mode. (*1)
10: Reading stop
This command stops operation during
reading (VGATE OFF, return).
Note:
™Ready∫ is the response when this command ends normally.
*1 If the CONTROL REGISTER CLEAR command is issued after the READ
command is sent to the scanner but before the Read Complete is received from
the scanner, a command sequence error occur.
6 $ 6 50FH5037E>02