Filter
Top Products
Picking is specified when the scanner is required to read a special area as shown
below.
Front side of scanner
Reference point
Document
board
Area to be
scanned
A
B
Picking is applied when bit 5 of the control register #5 is ™1∫ and the address of
points A and B is specified in the control registers #10 to #17.
Note:
When these registers are specified, four consecutive registers (#10 to #13 or
#14 to #17) must be specified.
Ex.
(#15) (#16) (#17)(#14)
CNT CND REG.No. #10 #11 #12 #13
#14 #15 #16 #17#10 #11 #12 #13
Or.
CNT CND REG.No.
6 $ 16 50FH5037E>02