Filter
Top Products
(4) CAMERA SETUP
This camera has an external control input interface (RS-485). All parameters and adjustments can
be changed from an external unit.
Refer to the section on External Control Input Terminal in details.
In this menu, setting of the communication, LED and Switch can be selected.
Fig.10 CAMERA SETUP menu
ADDRESS
The number to identify two or more cameras is specified. It is possible to communicate up to 30.
Note) When the number is repeated in the system, cameras don’t operate correctly.
COM SPEED
The communication rate with an external unit is selected.
2400, 4800, 9600, 19200
LED
When Direct-key function is active, LED illumination can be switched ON or OFF.
SWITCH
This item can be selected enable or disable setting of Direct-key function.
ON : enable, OFF : disable
(5) LENS ADJUSTMENT
The mechanical iris adjustments involve fine adjustments of variations in the mechanical iris
reference voltage. Before using this camera, do this adjustment.
Fig.11 LENS ADJUSTMENT menu
Operation procedure
1. Move the cursor to LENS ADJUSTMENT and press the SW. LENS ADJUSTMENT menu is
displayed.
2. Move the cursor to OK and press the SW. The adjustment is executed.
At this time, make adjustment with a bright and flickerless scene.
3. The screen automatically reverts to MAIN MENU when the adjustment process ends.
Note) When you change the lens, do this procedure again.
CAMERA SETUP
ADDRESS
COM SPEED
LED
SWITCH
RETURN END
→ 1
→ 4800
→ ON
→ ON
LENS ADJUSTMENT
OK CANCEL
En-21