Fujitsu CG-301 Camcorder User Manual


 
EXTERNAL CONTROLS AND CONNECTORS
TOP/FRONT VIEW
3
321
CAMERA MOUNT
ADAPTER
6
8
9
10
4
75
BACK VIEW
Lens Mount
The camera has a standard CS lens mount but can use a C-mount lens when a C/CS-mount adapter is installed
between the lens and camera.
Back Focus Lock Screw
Loosen to adjust the back focus to match the lens attached to the CS mount. Refer to the section on Back Focus
Adjustment in this manual.
Camera Mounts
Top or bottom mounting. Maximum thread length is 3/16-inch. Attach the camera mount adapter to extend
thread depth to a standard 1/4-inch.
Video Output Connector
This coaxial connector (BNC type) outputs the video signals.
Lens Connector
Four-pin DC-control connector for auto iris lens. Refer to the section on Lens in this manual for pin connections.
RS485 Terminating Switch
This is the switch to terminate between signals of RS-485.
ON : Terminated with 100 ohm. OFF : Not terminated
LEDs
LEDs light up or blink while using Direct-key function and displaying Camera Setup Menu.
Refer to the section on Setting Operation in this manual.
Setup Switch
This is the switch to display and operate the menu when OSD function is used. And when Direct-key function is
used, it is used for the selection of ON or OFF. Refer to the section on Setting Operation in this manual.
Power Input Terminal
Three-pin terminal strip, push-in type; 24 VAC/12 VDC for NTSC/PAL models.
External Control Input Terminal
This is the I/O terminal of the signal with an electronic characteristic in accordance with RS-485 standard. In
addition, it is the control signal input terminal for DAY&NIGHT function.
En-6
Fig.1