Filter
Top Products
10 TruVision Mini PTZ 12X Camera
Pocket Guide
To set the dome camera protocol
1. Locate the protocol DIP switch block (A, Figure 1).
2. Set the DIP switch sequence for the desired protocol. See
Table 2 below for the most frequently used protocol
settings. For other supported protocols, please refer to the
user manual.
Table 2: Dome camera protocols supported
Protocol Switch position
GE Impac RS-485
(Baud rate: 9600)
GE Digiplex RS-422
(Baud rate: 4800)
Setting the communication DIP switches
See Figure 1 for the location of the communication DIP
switches. The RS-485 default setting is half-duplex (see Figure 2
below.) For further information on the other options available,
please refer to the user manual.
Figure 2: Default setting of RS-485 communication switch
(half-duplex)