Filter
Top Products
14 TruVision Mini PTZ 12X Camera
Pocket Guide
To wire the dome camera
1. Connect the 22-pin connector of the I/O interface cable to
its connector in the base of the dome camera. See
Figure 1 for its location.
2. Connect the crimp-on BNC connector of the video output
to the coaxial video cable of a monitor or DVR.
3. Connect the control keyboard to the dome camera
through the serial terminal block.
4. Connect the alarm cable to a dry contact. For example, a
PIR detector, or an access control system.
5. Connect the RS-485 serial data connector to the
DVR/keypad, as shown below.
Figure 5: 2-wire connection from a DVR/control
keypad/PC to the dome camera
6. Connect the power cable to the power source. As soon as
the dome camera is connected, it is operational.
Note: The ground wire must be inserted into the center
pin of the power input terminal block. See Figure 6 on
page 15.