Filter
Top Products
SKU 94634 For technical questions, please call 1-800-444-3353 PAGE 19
INSPECTION, MAINTENANCE, AND CLEANING
1. WARNING! Make sure the Power Switch (14) of the Curb Machine is in its “OFF”
position and the machine is unplugged from its electrical outlet before performing
any inspection, maintenance, or cleaning procedures.
Before each use,2. inspect the general condition of the Curb Machine. Check for
loose screws, misalignment or binding of moving parts, cracked or broken parts,
damaged electrical wiring, and any other condition that may affect its safe operation.
If abnormal noise or vibration occurs, have the problem corrected before further
use. Do not use damaged equipment.
After each use, 3. clean the Hopper, Chute, Slip Form, and exterior Body of the Curb
Machine thoroughly with water. Do not introduce water into the Motor compart-
ment of the machine.
To replace the V-Belt, 4. loosen the four Bolts (48) at the base of the Motor (25). Move
the Motor towards the Gear Box (24). Slip the V-Belt (20) off the two Pulleys (21,
23). Install a new V-Belt (size A500) onto the two Pulleys. Move the Motor back to
its original position. Then, firmly retighten the four Bolts.
(See Assy. Diagram.)