Filter
Top Products
SKU 94634 For technical questions, please call 1-800-444-3353 PAGE 20
TROUBLESHOOTING
Problem Possible Solution
Curb Machine will not turn on. Make sure the Power Switch is in its “ON” position.1.
Make sure to use the proper size extension cord.2.
Make sure the extension cord is connected to a working, 115 3.
volt, grounded, electrical outlet.
Have a qualified service technician examine the machine.4.
Curb Machine extrudes poorly. Make sure to properly mix the cement, sand, and water.1.
Make sure the Slip Form is properly attached to the machine.2.
Make sure to properly feed the Hopper.3.
Make sure the Compaction Ram is moving freely on its Track.4.
Make sure the Crank Arm has been properly adjusted (length 5.
and stroke of the Compaction Ram) for the job at hand.
Have a qualified service technician examine the machine.6.